Product Description
PC based code reader and live data scan tool for cars including 800 Series, C70, S40, V40, S70, V70, 900 series, S90 and V90
Serial Diagnostic Cable Features and Benefits:
1 New Design! 232 Chipset based design
2 Works excellently fault code reader 1.3 serial
version Serial port design, supports the most challenging time-critical application like serial EEPROM programming
3 Supports FCR version 1.3 or older
4 Precision-molded diagnostic connector made to fit all vehicles, even those with "tight" trim around diagnostic socket
5 LED light indicating communication status
6 High quality UL certified Serial Cables (equivalent to CE)
7 Built-in, Electronic Protection from the "Aftermarket Radio Problem"
8 control module coverage includes:
-Engine - Petrol and br />-ABS
-Automatic transmission
-SRS - airbag and other protection systems
-Driver and passenger seat memories
-Instruments, including service light reset
-Climate control - air conditioning
-Immobilizer
-Alarm
-Road traffic information
-Additional heater
Supported Software:
Onboard Diagnostics Versions: 1.3
FCR Communication Interfaces to connect a Vehicle to a PC
FCR is a Windows-based Diagnostic Software for that emulates the functions of the dealers` very expensive proprietary scan tools. As the first aftermarket -Tool
What can this interface be used for?
This interface (adapter) is used as an interface and an Serial cable to connect a vehicle to a PC for on-board diagnostics (OBD). It is fully compatible with the diagnostic software version 1.3 from FCR. FCR is a software program that turns your PC into a sophisticated diagnostic tool.
How to Use?
-For laptops and PCs, download the shareware 1.3
-Run it and follow the prompts to allow it to install itself.
Note: You must install FCR on your PC`s hard disk -- it will not work properly if you try running it directly from a floppy or CD. However, you can use a floppy or CD to move the distribution file from a PC with internet access to another PC that does not have internet access.
-Connect the interface between the computer and the car by plugging one end of the interface into a Serial (RS232) (or USB port ) on your PC and the other end directly into the OBD-II port present passenger vehicles.
-Turn the car’s ignition switch ON. No need to start the engine.
-Start the program,
-Now it works. Make sure the software can reliably access all the control modules that it should in your car.
What are the system and computer requirements?
-A PC running Windows: It is recommended to use at least a Pentium-100 (or AMD equivalent) with 16MB of RAM and Windows 95 or newer. FCR may work on some lesser PC`s, but anything less than the above recommendation is unsupported. Windows 95, 98, ME, NT4, 2000, and XP are all fine. Available disk-space is a total non-issue, FCR requires less than 1 MB.
Packing List:
1pc x CD Drive
